How To Load A Pneumatic Stapler

Learn how to load your air stapler properly. Loading a pneumatic stapler varies slightly from tool to tool, but the following instructions demonstrate how to load most common models. Learn more on Nail Gun Depot.

First, you must ensure you have the proper staple - this will determine whether or not the tool can even be used. After identifying the correct staples, you are ready to load them.

Most staple guns are either top or bottom loading. Medium and heavy wire pneumatic staplers generally load from the top, while most fine wire staplers are bottom load. Before loading, be sure to disconnect the air supply and keep the stapler pointed away from you.
A top loading stapler is fairly straight forward. Pull the magazine follower back until it locks into position. After the follower is locked into position, place the strip of staples over the magazine rail. The staples should move freely back and forth on the rail. The last step is to unlock the follower and release it so that it pushes the staples into the nose of the staple gun for firing.
Bottom load staplers operate differently. First, locate the magazine release, generally found at the rear of magazine. Depress its release and slide the magazine rail away from the nose. Turn the stapler upside down and insert the staples into the channel toward the nose of the stapler. After the staples have been loaded, slide the magazine rail back toward the nose until it locks into place.
 
Now you are ready to connect your air supply and test fire.
 

~ The Nail Gun Depot Team