CALL CART ACCOUNT

ITEMS IN CART: 0

$0.00

translate
Tag Archives: air powered tools
  • How To Avoid Destroying Your Pneumatic Nailer

    Basic maintenance on a pneumatic nailer can slash unnecessary repair costs, and will keep your air-powered nail gun running like new. But, despite minimal effort required for preventative maintenance, we continue to see far too many pneumatic tools reduced to scrap from lack of service. We've previously covered how to protect your pneumatic tools and compressor from cold temperatures - but what about year-round maintenance? Take a look at these professional maintenance tips to extend the life of most pneumatic tools, protecting your investment.
    FramePro325XPAction1
    Depending on the region, a big risk to any pneumatic tool is simply the environment it inhabits. Airborne particles can clog pneumatic nailers and cause undue wear to components within the tool. This is particularly true in coastal regions, where moisture and salt in the air increases the chance for system failure, rusting or corrosion. In areas with high moisture content in the air, it's extra important to avoid prolonged exposure to the elements. Invest in a systainer case or air-tight box to store pneumatic tools that are not in use. The same principle applies to areas that have a lot of dust or sand in the air - particularly when talking about prolonged exposure at a job site.
    Hitachi NV45AB2 Coil Roofing Nailer
    A universal rule for protecting and prolonging the life of a pneumatic nailer, make sure the tool is properly lubricated at all times. A regular cause for air nailer failure is component wear due to lack of lubrication. Just like you wouldn't drive a car without oil in the engine, a pneumatic tool requires the same attention. It's also crucial to note that pneumatic nailers and staplers require special lubricant, specifically labeled as pneumatic tool oil. Many generic lubricants eat through rubber over time, which will cause more harm than help in the long run (remember most pneumatic nail guns have rubber o-rings). NEVER use WD40, motor oil, transmission fluid or aerosol lubricants.
    Unless specified otherwise by the manufacturer, make sure pneumatic nailers, staplers and other fastening tools receive regular lubrication to moving parts. Even with a self-oiling valve design, it's important to keep watch that your pneumatic nailer is receiving the proper amount of lubrication. In general, we recommend putting two or three drops of pneumatic tool oil directly into the coupling joint, before connecting the air hose. Do so daily at the start and finish of use - and be sure to fire the tool two to three times to give the oil a chance to work through the valves.
    Surprisingly enough, many other causes for system failure on a pneumatic nailer can be prevented by simply using the tool properly. Before firing the nail gun, make sure you are using the correct size and type of nail. Pay careful attention to the nail's angle, as well as the collation.
    You'll also want to check the manufacturer's recommended operating pressure, before hooking up an air compressor, to avoid misfiring caused by inadequate air flow. Too much air pressure can drive nails too deep - whereas too little pressure can cause nails to not sink evenly. Furthermore, consistently using improper air pressure can damage the pneumatic tool over time.
    Make sure you are using the proper size air compressor too. For finish and trim work, small hand-carry compressors will typically perform adequately. For framing tools, or if you are planning to connect multiple air-powered nailers, larger wheelbarrow compressors could be a better fit.
    rolair compressor at jobsite
    As always, safety should be top priority. Always consult your owner's manual, or visit the manufacturer's website for detailed information about your pneumatic tool. For more maintenance advice, consult a certified repair center.
    Keeping Your Pneumatic Nailer On The Job,
    The Team At Nail Gun Depot
    Read More
  • 1 Item(s)

Copyright © 2017 Nail Gun Depot All rights reserved. All trademarks and brands are property of their respective owner